A roll of new orange rubber necklace cord . The cord is 2.5mm diameter and the roll is 20mtrs long so enough for over 30 necklaces .

New and unused.

1 length of 8mm i.d propane hose , 3.5mtr long , new but just an end of roll.

1 length of 6mm i.d propane hose , 3.0mtr long , new but just an end of roll.

Reichenbach 94coe "Luck of the Iris" big rocks , this is a very special colour and size , much larger than normal frit and offers lots of opportunities.

Reichenbach 104coe , a massive bundle of "Oddment" glass rods

31 x rods approx

This is a sheet of 3mm opaque lime green /leopard design

CoE unknown but assume 96 or could be used for stained glass.

Size 38cm x 29cm, slight wedge broken off one corner

Very , very rare that this still pops up in clearance

104coe

Very , very rare that this still pops up in clearance

104coe

A steel reducer joint, the joint is good clean condition and reduces from 150mm down to 100mm.

A "Used" stainless steel rod rest , a mandrel stand that can go at the back of the kiln to get more mandrels in and a ridged pr of mashers.

This is a "Used" tool pack . The pack contains a stainless steel rod rest, a pair of glass rod nippers and a small brass doming block. 

Nice little kin , the discolouration above the bead doors is normal with the heat when annealing , all kilns look like this. The internal chamber is clean and intact .

Chrome mandrel racks are fitted at the fount and we have replaced the relay.

A "Used" pack of frit by "Beady Sam"

Frit Blends are "carnival", "mint sparkle", "fresh" & "blue/purple"

A "used" pair of mashers .

1 set is flat ribbed mashers measuring 25mm wide x 35mm long

1 set is lentil mashers measuring 30mm di

A steel "Y" joint to fit 100mm dia tube , good condition.

A "Used"  Skutt fusing kiln in excellent condition , single phase but needs wiring in by a professional . The kiln is a top opening clam shell measuring 700mm external dia , 600mm internal dia and 480mm high with all the controllers and a box of shelf posts and extra bits , it will be delivered on a pallet as it is far too heavy to post.

Side elements and roof elements are fitted.Stand included.

Over £3000.00 new retail price plus all the extras extras

A "Used" stainless steel rack for stacking mandrels in the kiln , this increases the number of mandrels you can get in the kiln as you can stack low and high , the rack fits both Paragon SC2, SC3 kilns and Bluebirds, Bluebird XL kilns

Measurements are 150mm long x 70mm deep x 50mm high

A used set of propane and oxygen nut and tail . The pair is in good condition , the threads are clean . We have added a set of jubilee type clips and "O" rings